EMERSON ER100301 SERIAL NUMBER
EMERSON ER100301 MANUAL
EMERSON ER100301 FULL
EMERSON ER100301 BLUETOOTH

You only do this one time and the SmartSetwill remember the new default zone setting and will always return to that setting after power interruption.

If you do not live in the Eastern Time zone you must change the default zone display to your own zone.

The display will scan for a few seconds and then show the correct Day and Time in the Eastern zone.

The first time you connect your new SmartSet clock radio to the AC outlet the internal computer will automatically set the time correctly for the Eastern Time Zone.

BACKUP BATTERY Compartment (located on back of unit).

Location of Controls and Indicators FRONT PANEL To maximize the life of the lithium battery keep the radio connected to a ' live' AC outlet at all times the built-in lithium battery takes over to maintain the time and alarm settings. When the power to the radio is interrupted. Do not connect it to an outlet that is controlled by a wall switch. This radio should be connected to an AC outlet that is always 'live’. You could cause damage to the radio that is not covered by your warranty.

This radio is designed to operate on normal 120V 60Hz AC power only.Do not attempt to operate the radio on any other power source.

and apply these pads to the bottom of the rubber feet before you place the product on fine wooden furniture. available at hardware stores and home improvement centers everywhere. To prevent any damage to your furniture we strongly recommend that you purchase small self-adhesive felt pads.

and leave marks or a rubber residue on the furniture. r cleaning sprays may cause the rubber feet to soften. However certain types of oil based furniture polishes. These feet are made from non-migrating rubber material specially formulated to avoid leaving any marks or stains on your furniture.

This model is equipped with non-skid rubber feet to prevent the product from moving when you operate the controls.

It must be fully extended to provide the best FM reception.

EMERSON ER100301 FULL

Unwind the Line cord connecting the AC adapter and extend into its full length.Place your radio on a level surface such as a table.

EMERSON ER100301 SERIAL NUMBER

Note the serial number on the bottom of your radio and write this number in the space provided on the Warranty page of this manual.

Do not remove any labels or stickers from the back or bottom of the cabinet.

Remove any descriptive labels or stickers on the front or top of the cabinet.

The original carton and packing material is the only Safeway to pack your radio to protect it from damage in transit.

Remove the radio from the carton and remove all packing material from the radio.Save the packing material if possible.

EMERSON ER100301 MANUAL

USER MANUAL SmartSet Alarm Clock Radio PREPARATION FOR USE

EMERSON ER100301 BLUETOOTH

The LOW BATTERY indicator should then be Off.Emerson ER100301 SmartSet Alarm Clock Radio with Bluetooth Speaker, Night Light and USB Charging Port - Use Manual - Use Guide PDF. Unscrew the battery holder from the cabinet with a small screwdriver and insert a new battery with the same CR2032 (3V) or equivalent type into the holder the same way, observing the positive (+) polarity before sliding the holder back into the slot. Leave the AC adapter connected to your AC outlet to retain memory while the original battery is removed.ģ. The lithium backup battery needs replacement when the LOW BATTERY indicator ﬂashes, otherwise, the time and alarm settings will be lost/reset after a power outage.Ģ. To reconnect this unit, just select ' ER100' again from the Available/Paired device list.ġ. If you want to disconnect this unit from your Bluetooth enabled device after pairing successful, press and hold the “BT PAIR” button for 2 sec. Then, set this unit to Bluetooth mode, and tap the Bluetooth switch on your phone/device off and back on again to refresh/ search any nearby ' ER100' for pairing. Note: If pairing unsuccessful, all previously paired Bluetooth devices around should be disconnected or turned off ﬁrst, in order to avoid making any auto reconnection between them.

Emerson er100301